Showing 11–20 of 72 results

OP5U Controllers for simple applications

OP5U Pre-programmed, configurable controller for
simple applications
• Language independent
• Simple configuration via the backlit display
• Input for external setpoint device
Optigo is a series of pre-programmed, configurable
controllers intended for DIN-mounting that can be set to
handle everything from temperature or humidity control
to CO2 and pressure control. Features also include
a general control usable for several different control
modes.
• Pre-loaded with several application modes
• Simple handling using push-/turn knob
• Temperature sensor input can be set to
three different ranges

OP10 Controllers for simple applications

OP10
Pre-programmed, configurable controller for
simple applications
The Optigo OP10 range of controllers controls
temperature. They are intended for DIN-rail mounting.

Language independent
• Simple configuration via the backlit display
• Input for external setpoint device
• Pre-loaded with several application modes
• 24 V or 230 V AC supply voltage
• Week-based clock / calendar function

DMD-C Differential pressure transmitter with built-in controller

DMD-C
DMD is a differential pressure transmitter for air and neutral gases. The unit has LED-display and built-in controlling function. The main application is for pressure control in air handling systems.

 

Selectable measuring range 0…100, 0…300, 0…500, 0…1000 Pa
Pressure signal output 0…10 V and 4…20 mA
Controls output 0…10 V
Adjustable damping of the measuring signal
Zero-point adjustment

REGIN AL24A1K Duct controller, one 0…10 V DC output

REGIN AL24A1K Duct controller, one 0…10 V DC output

 

Duct controller, one 0…10 V DC output
Compact controller for mounting in ventilation ducts. The controller has a built-in sensor and setpoint
control. An external setpoint potentiometer can be connected if required. Can be used to control either
heating or cooling. P- or PI-control optional.
The controller has an input for change-over between heating and cooling. The change-over function can
be activated by means of an external closing contact or a sensor mounted on the supply-water side of the
heating/cooling unit.

HCA151DW-3 Exigo Ardo 4.1 – Controllers for heating, 24 V

Exigo Ardo
Controllers for heating and boiler control

Easy installation: Connect the controller, set
the parameters and star t up
99 Easy configuration using Exigo Tool
99 Suppor ts control of up to four heating/cooling
circuits, two domestic hot water circuits,
four boilers, one solar circuit, one buffer tank
and district heating
99 Communication via BACnet, Modbus, EXOline
and M-Bus
99 Versatility through number of por ts and
expansion units

HCA281DW-3 Exigo Ardo 4.1 – Controllers for heating, 24 V

HCA281DW-3 Exigo Ardo 4.1 – Controllers for heating, 24 V

Easy installation: Connect the controller, set
the parameters and star t up
99 Easy configuration using Exigo Tool
99 Suppor ts control of up to four heating/cooling
circuits, two domestic hot water circuits,
four boilers, one solar circuit, one buffer tank
and district heating
99 Communication via BACnet, Modbus, EXOline
and M-Bus
99 Versatility through number of por ts and
expansion units